R&R Devices TC Install

Traction Control Module Installation Instructions

*CLICK HERE FOR INSTALLATION DIAGRAM*
How it works

The Control Module can remember how your Factory Traction Control Switch was set the last time you used your car. If it was off, it will stay off until you turn it on. If it was on, it will stay on until you turn it off. The original switch works the same way as always, it just remembers it's last setting instead of always defaulting to always on (factory setting) when you start your car.

Preparation

Please read all instructions and review wiring diagram before beginning installation.
If you feel that this installation is too difficult, please have a professional do the installation for you.
Remove the interior trim as necessary to gain access to the Traction Control Switch and Wiring Harness.
Unplug Traction Control Wiring Harness connector and remove tape for easy access.

Installation

Step 1. Tap the Black wire from Control Module to the Black wire going between the Traction Control Switch and Harness Connector using the tap supplied.
Step 2. Tap the Red wire from Control Module to the Pink / Black stripe wire going between the Traction Control Switch and the Harness Connector using the tap supplied.
Step 3. Cut the Gray wire going between Traction Control Switch and Harness Connector near the center of the wire. DO NOT REMOVE any excess wire. Connect the Green wire from the Control Module to the Gray wire connected to the Traction Control Switch using the butt connector supplied.
Step 4. Connect the White wire from the Control Module to the Gray wire going to the Traction Control Harness Connector using the butt connector supplied.

Testing

Step 1. Plug the Wiring Harness connector back in.
Step 2.Turn on the key
Step 3.The green LED will flash several times and then remain on.
The yellow LED will flash once if the traction control was enabled, it will not flash at all if it was disabled during the initial sequence.
Step 4. Press the traction control button once.
Step 5. Turn the key off and wait 10 seconds.
Step 6. Turn the key on again. The green LED will flash several times and remain on.
The yellow LED will not flash if it flashed during testing in step 3 or it will flash once if it did not flash once in step 3. Replace Interior trim as necessary

Disclaimer

Neither the Vendor nor manufacturer is liable for incorrect installation or misuse of this product. Damage to the vehicle can occur if the Control Module is not installed correctly. Installation of this device may void your vehicle's warranty. The buyer agrees to hold the Vendor and manufacturer harmless in any legal proceeding regarding the installation of these parts

Opening the Control Module will void warranty and make the unit inoperable.